發新話題
打印

DGS-3324SR L3 swtich管理介面ip

DGS-3324SR L3 swtich管理介面ip

DGS-3324SR L3 swtich管理介面ip

ftp://ftp.dlink.com/Switch/dgs3324SR/Manual/DGS3324SR_manual_4x.zip



To use the console port, you need the following equipment:
·  A terminal or a computer with both a serial port and the ability to emulate a terminal.
·  A null modem or crossover RS-232 cable with a female DB-9 connector for the console port on the Switch.
xStack Stackable Gigabit Layer 3 Switch Manual
37
To connect a terminal to the console port:
1. Connect the female connector of the RS-232 cable directly to the console port on the Switch, and tighten the
captive retaining screws.
2. Connect the other end of the cable to a terminal or to the serial connector of a computer running terminal
emulation software. Set the terminal emulation software as follows:
3. Select the appropriate serial port (COM port 1 or COM port 2).
4. Set the data rate to 115200 baud.
5. Set the data format to 8 data bits, 1 stop bit, and no parity.
6. Set flow control to none.
7. Under Properties, select VT100 for Emulation mode.
8. Select Terminal keys for Function, Arrow, and Ctrl keys. Ensure that you select Terminal keys (not Windows
keys).
9. After you have correctly set up the terminal, plug the power cable into the power receptacle on the back of the
Switch. The boot sequence appears in the terminal.
10. After the boot sequence completes, the console login screen displays.
11. If you have not logged into the command line interface (CLI) program, press the Enter key at the User name and
password prompts. There is no default user name and password for the Switch. User names and passwords must
first be created by the administrator. If you have previously set up user accounts, log in and continue to configure
the Switch.
12. Enter the commands to complete your desired tasks. Many commands require administrator-level access
privileges. Read the next section for more information on setting up user accounts. See the xStack Command
Line Interface Reference Manual on the documentation CD for a list of all commands and additional information
on using the CLI.
13. When you have completed your tasks, exit the session with the logout command or close the emu lator program.


Once connected to the console, the screen below will appear on your console screen. This is where the user will enter
commands to perform all the available management functions. The Switch will prompt the user to enter a user name and a
password. Upon the initial connection, there is no user name or password and therefore just press enter twice to access the command line interface.

Logging on to the Web Manager
To begin managing your Switch, simply run the browser you have installed on your computer and point it to the IP address
you have defined for the device. The URL in the address bar should read something like: http://123.123.123.123, where the
numbers 123 represent the IP address of the Switch.
NOTE: The Factory default IP address for the Switch is 10.90.90.90. (dlink 每次預設都是這個啦!!)


Leave both the User Name field and the Password field blank and click OK. This will open the Web-based user interface.
(預設都是空白), 好了可以開始玩了.

TOP

發新話題