chun

How do I access the SafeMode menu?
When the device is running, you can access the SafeMode menu from the ‘System > Settings’ menu (it
will be under the ‘Firmware Management’ section). In emergency situations, you can also access the
SafeMode menu by holding in the Reset button on the front panel of the 3060/4060 (it’s the small pinhole
button between the Console port and the LAN interface) for 12-14 seconds until the ‘Test’ light begins
flashing red. If you have a Console session open, you will see the following dialog:
SonicROM Booting.............................
Initializing Firmware loader
SafeMode Switch Pressed
Initializing SafeMode
Starting SafeMode WebServer on 192.168.168.168
Also Starting SafeMode WebServer on (your LAN IP here)
Your SonicWALL is now running in SafeMode.
Connect to the SafeMode WebServer on 192.168.168.168
-Upload and download firmware images and system settings.
-Boot to your choice of firmware and settings.
-Manage system backups.
-Easily return your SonicWALL to a previous system state.
When the SonicWALL is booted into the SafeMode menu, connect a workstation to the LAN interface of
the 3060/4060 and access the special SafeMode GUI using the default IP address of 192.168.168.168, or
the device’s previously saved LAN interface IP address. You will be able to boot the device using a
previously saved image, boot the device from a known-good ‘Factory Default Image’, or you can upload a
new version of firmware with the ‘Upload New Firmware’ button.